The quality of the wood chips from different manufacturers' lumberjacks is quite different. There are many kinds of factors that have never affected the quality of wood chips, such as the technology of lumberjacks, wood humidity, machine quality, blade length, and firmness of wood. The selection of cutting tools for Lumberjack Log Splitter. The sharpness of the cutting tools directly affects the quality of the chip. There are two types of flying knife blades: single-edged and double-edged. To ensure the sharpness of the blade, the blade must be regularly ground and replaced. Under normal circumstances, the flying knife should be replaced every 4 ~ 8h, and the bottom knife should be replaced every half month. . The blade device, the length and thickness of the material slice of the lumberjack splitter are determined by the device orientation and viewpoint of the blade, and the width of the chip is formed by natural cracking, which depends on the shear strength of the material. Usually it is slightly smaller than the length of the chip. Request all blades to extend the same amount, and adhere to the distance between the flying knife and the bed knife. There are many impurities in the processed materials. Lumberjack splitters usually process a single variety of materials. They never mix materials. Let's take processed wood as an example and use logging. Wood splitters are usually used to make paper or make incense, and the requirements for the fineness of the materials are very high. If the bark on the wood has not been cleaned, use a wood splitter. After processing, the fineness of the processed materials is naturally low, so we must choose the materials with high cleanliness when selecting the processed materials. Due to the lack of timely cleaning, there are many types of materials processed by Gasoline Log Splitter, and after each use, a certain amount of materials will remain in the equipment for a long time. Changes will occur, even if we have been pulverizing a material, but the failure to sort out the remaining materials before will affect the fineness of the product materials, let alone replace the processed materials, so we must timely equipment The remaining materials are sorted out.