Usually when the user imagines the manufacturing process of a Lumberjack Log Splitter, he thinks that the design method of the machine is relatively simple. It only needs to put materials into the machine to process into wood chips. In fact, it is not so easy. The machine is in production. Problems will inevitably accompany the process. This is inevitable. No manufacturer can pack tickets to say that there are no technical problems in production. Let's answer two technical problems in detail: First, a large number of forced feeding, horizontal feeding and ultra-thick wood (thickness greater than 12cm) by the Lumberjack Log Splitter are the main reasons for the feed roller jam. Reasonably control the feed amount, and it is strictly prohibited to directly enter the machine with thick materials and large bundles of materials larger than 12cm. Ensure that the raw materials are fed in the length direction to prevent horizontal feeding. If the raw materials are stuck in the feeding mechanism, the sticks must be pushed down between the upper roller of the drum and the sparse board. Do not use iron parts to avoid them. Falling into the aircraft caused a serious accident. Second, the pressure of the Lumberjack Log Splitter fan is reduced, the pump head speed is reduced, its power supply voltage is low or the motor is faulty, the pipe network resistance is increased, and the pipe network resistance is reduced; the working state is changed to adjust the working state; Reconnect the motor. The vibration of the machine is increased: bearing damage-replacement of bearings, imbalance of fan impeller-removal of foreign objects in the impeller or calibration of dynamic and static balance, deformation of the main shaft-replacement of the main shaft or pump head, working condition enters the end-vibration zone-adjustment of working condition to avoid end-vibration Area, the inlet and outlet air filters are blocked-clean the filters. The fan flow is reduced: the inlet and outlet gas filters are blocked-the filters are cleaned, the pump head speed is reduced-the power supply voltage is low or the motor is faulty, the pipe network resistance is increased-the pipe network resistance is reduced, and the working state is increased-adjusting the working state, its motor Steering in reverse—Motor reconnected. Of course, experienced operators will do the relevant preventive work before the Gasoline Log Splitter is in production to minimize the damage caused to the machine by the problem. When we encounter the above problems, we need to deal with them reasonably through certain skills and methods. The solution must be determined according to the actual situation, or appropriate adjustments should not be made. This will not affect the production quality of the machine. Make an impact.
