Most of the products for daily necessities require waterproofing, which requires that the products produced by Daily Necessities Mould(FURNITUREMOULD) processing factories cannot produce cracks. Sometimes the products produced were not available at that time, but they were available after a month, resulting in a large number of returns, not worth the cost. Today, I will give you an analysis of the reasons and solutions: It is normal for daily necessities to mould to be sensitive to burrs and cloaks. Material cloaks or burrs are very small, but they become hard and large after electroplating. Summarize the material defects that need to be paid attention to in the electroplating process of daily necessities mould and wiredrawing products. To make any product, one needs to know the characteristics of other products. Only in this way can the production process better control it and rapidly welcome batch after batch of high-end customers for the enterprise through efficient control. When hearing about the return of the products due to cracks, the daily necessities mould processing factories burn their brains, not only wasting manpower and material resources but also affecting the credibility of the problem. After many years of experience, there are generally the following reasons: 1. the mould is too cold, 2. the cooling time is too long, 3. the shrinkage rate of plastic and metal inserts is different, 4. the ejection device is unbalanced, and the ejection cross-sectional area is small or improperly distributed, 5. the manufacturing inclination is not enough, and demoulding is difficult. Principle of surface quality of daily necessities mould of the thermal cycle: in order to improve the surface quality of injection moulded products, to improve the spraying technology during manufacturing around plastic surface quality, and to reduce poorly formed injection moulded products, it is the overall improved quality. Important aspects of daily necessities mould design and manufacturing. In order to meet the requirements of plastic products, high performance, low cost and environmental protection, the rapid thermal cycle injection moulding technology was born. According to the principle of daily necessities mould, the system configuration of the new injection moulding process was studied. It studied the actual principles and requirements to establish a stable production line in production. If you are interested in our products, you can click Furniture Mould to learn more information.
