According to the problems encountered in actual production, the air cooler mould and everyone discussed how to do better maintenance of the Air Cooler Mould(FURNITUREMOULD). First of all, establish the air cooler mould file and make preparations. (1) That is to say, to establish a complete set of usage records for each set of air cooler mould when entering the factory, which is an important basis to ensure future maintenance and maintenance. Each piece should be done carefully and clearly, including daily production mould times. (2) As a mould manager, after the mould enters the factory, the structural fittings of each part of the mould must be recorded in the mould file in detail, and the vulnerable parts in the mould must be listed as required, and fittings such as mandrels and cores should be prepared in advance. Establish a minimum inventory of vulnerable spare parts so as not to delay production due to insufficient preparation. Because there are many such lessons, only when you are prepared can you be safe? If the production is delayed because they have not prepared spare parts, the losses incurred by the die casting enterprises are very large. The time, manpower and electricity (or liquefied gas) used by the heat preservation furnace are not small. The main reason is that the production is delayed and the delivery loss will be even greater! (3) It is necessary to engrave permanent marks on the mould itself while making a history card for the air cooler mould, which is easy to distinguish. (4) If there is a mould with an oil cylinder core-pulling device attached, match it with a quick-change joint as soon as possible, otherwise the money wasted by the oil leaking from the oil cylinder every time the mould is disassembled will be enough to pay several employees a month's salary, and you can also use the saved money to improve the food for employees. This also greatly shortened the time for die-casting operators to load and unload the dies and achieved several results. Remember to buy some quick connectors of good quality, otherwise, it will backfire. (5) Formulate the air cooler mould management regulations in advance, train the employees systematically, and carry out them practically. If you are interested in our products, you can click Furniture Mould to learn more information.
