If you have to work on plastic injection moulding, it is important to learn about a few tips to help make your work easier. It is not uncommon to encounter some problems from time to time. Having a good understanding about what to do can have you finish your projects properly and do a perfect job.It is advisable to work on plastic injection moulding as it is recommended by manufacturers. Consider checking out some of conditions first and understanding how the environment changes with time. This allows you to select the best materials for the project.If you are working on short cable tie mould and you are not able to get adequate shot capacity, the following tips can help. Consider increasing feed settings so as to get the desired effect. Try to also confirm that the rate of plasticizing is as recommended by manufacturers. Failure to make such changes can lead to inconsistent work.You can also consider transferring the material to a larger capacity machine. This is a good solution if you are working on shot mouldings but you are unable to get adequate shot capacity.Another problem associated with this type of mouldings is whereby the material freezes off even before one has filled the mould completely. There are a few things that can be done. You can consider increasing the injection time. If doing this does not solve the problem, consider raising the temperature of the material. This should be done gradually and evenly.Other useful solutions you can use include using a higher MFI grade. It easily solves the problem. Also find out if the venting is adequate. Some of the things to check out in this case include purge gates, runners and events. To correct the gates, find out if it is possible to enlarge them. The same should be done to runners and vents. Finish by balancing where necessary.