DG/ML divides the long stitches into shorter ones and makes the stitch points randomly distributed so that they do not form obvious lines in the shape. 4. Or, use user-defined segmentation to manage the segmentation line of flat stitch filling. Tips As another option, change the stitch type to other stitches or pattern continuous and repeated division to get better results..If the flat stitch shape is too wide, some stitches may exceed the maximum stitch length that can be produced by a particular embroidery machine. This value can be less than the maximum stitch length usually used in pattern design. Select and right-click the object to be embroidered with flat stitches. Select the object properties. You can also separate the shape and digitize it into two embroidery objects. Stitches exceeding this value will be divided into smaller stitches. Select the Auto Split check box. If the band shape of the flat stitch stitch is only a few millimeters wider than the largest stitch, it is recommended that you reshape the band pattern.00 mm, you can keep the stitch effect of the flat stitch. If the band shape is too wide, you can use the automatic split stitch. How to split long stitches with automatic split stitch 1. Click OK with the mouse. Tips Although the automatic split stitch was China T-shirt Series Embroidery machine Manufacturers originally used to prevent the formation of long stitches in a wide ribbon shape, it can also be used to replace the tar meter needle for filling needles. Object properties>stitch fill stitch mark is turned on. The embroidery of long flat stitch stitches needs to be divided into smaller frames to move, with or without stitch points.Tip: Use the length value of 7. In the minimum stitch field, enter the shortest stitch that can be produced when using automatic split stitches. In the length field, input the maximum allowable stitch length of flat stitches before automatic division