Electric Bike Factory introduces the brake adjustment method of electric vehicles:When the brake is grasped to 1/2 of the non-braking grip distance, it should be able to brake safely, and when released, the brake handle should be able to reset quickly.1. Installation and adjustment of front and rear wheels of electric vehicle.Front wheel: set the front wheel into the front fork joint. Pay attention to the safety plate. Set the safety plate on the front axle and buckle it on the square hole of the front fork joint. After three months of use, the lock nut should be tightened once.Rear wheel: install the driving motor. After three months of use, tighten the locking nut once. Note: the tightening torque of the front wheel nut should be ≥ 18N• M (not front wheel drive); The tightening torque of the rear wheel nut should be ≥ 30N• m。2. Electric vehicle brake adjustmentScrew the elastic rope nut. Adjust the adjusting bolt to minimize the gap between the brake disc and the brake skin without interference, and lock the rope nut tightly. Note: It is forbidden to inject oil or water into the expansion gate.The above content is organized and shared by Fast Sport Electric Motorbike Manufacturer, hoping to help those in need.