Drywall Wear and Tear Reversal is as important and frequent, as is Drywall Wear and Tear. As drywalls are common and a number of house structures support such an installation on their walls, or have drywall as the walls of the house along with the pillars as separators in the rooms and halls, drywall wear and tear reversal is adamant. To begin with, once the type of drywall suitable for the use has been figured among the different types and thickness options of the wall available, the process begins with preparing the walls and sockets of the house for the drywall erection process as a whole. Once the adhesive has been applied the walls are all ready for the drywall wear and tear reversal as the wall pieces are to be installed. Now we go on to the remaining process. We first measure the space that is remaining. Add ¼ inch so that the installation is easier. Mark the second panels for perfect symmetry and neat outputs. Cut the paper backing with a knife along with smoothing the edges of the rough rasp. A scraping tool is used to scrape away and smoothen the rough edges of the recent cut paper. Use nails to get the second panel of the walls fastened firm as well. Mark Rotary Slitter Knife along the studs so you know exactly where to place the screws. Drive in the screws into the studs for a firm grip of the panel onto the wall. They need to be about 16 inches apart which can be said to be a safe distance for a good grip. When we are going through the process of drywall wear and tear reversal, we cannot forget along the installation of placement of electric panels and buttons to ensure that nothing is left behind. Make proper measures to ensure that the placement of boxes and panels later is not a problem. Lift the panel slightly from the floor with the help of a foot lift and put in the nails to ensure that the wall remains there. Make the cut out for the walls and windows in the panels. When joining the plates together, do not force the plates together as it provides room for cracks and breakage later. Do put them close but leave a gap of about 1/8 inches in between. The gap created then can be later filled in with joint compound later so that the gap is not evident and looks ugly. The seams and the joints need to be taped. Use mesh tape. It is more efficient than the other options available. After having covered the joints, in end cover the corners. This is about all of the process of drywall wear and tear reversal before we move on to the application of joint compounds to cover the gaps as well as other voids available in the walls. We shall discuss about the joint compound and its application methods in another article on another day.