6~0. The small footprint plate heat exchanger has a compact layout, and the heat exchange area per unit volume is 2 to 5 times that of a shell-and-tube heat exchanger.0~2. The layout of the shell and tube heat exchanger with high heat transfer coefficient is excellent in terms of strength, but it is not ambition from the point of view of heat exchange, because there are baffles-shells and folds when the fluid moves in the shell side. The plate thickness of the light-weight plate heat exchanger is only 0. In the plate heat exchanger, there is no bypass, and the corrugation of the plate can make the fluid turbulent flow at a small flow rate. If you want to know more about other knowledge, you can browse our website, We will provide you with more professional services. Therefore, the plate heat exchanger has a higher heat transfer coefficient, which is usually 3 to 5 times that of the shell-and-tube heat exchanger.5mm; the shell of the shell-and-tube heat exchanger has a larger layout than the plate heat exchanger Much heavier. The bypass between flow plate-heat exchange tube, pipe and shell.. We will introduce you to the advantages of plate heat exchangers. The thermal transfer oil cooler quotation is not high. Next, we will Everyone, let's introduce it in detail. It is loved by many industries. The above is our plate heat exchanger manufacturer. Therefore, when completing the same heat exchange mission, the floor space of the plate heat exchanger is about 1/5~1/10 of the shell-and-tube heat exchanger. Unlike the shell-and-tube heat exchanger, there is no need to reserve a controlled maintenance place. Simply change the heat transfer area or process combination. After the pressure plate of the plate heat exchanger is removed, the plate bundle can be loosened and the plates can be removed for mechanical cleaning. In the case of completing the same heat exchange mission, the heat exchange area required by the plate heat exchanger is smaller than that of the shell and tube heat exchanger.8mm, and the heat exchange tube thickness of the shell-and-tube heat exchanger is 2. You only need to add (or cut) plates to reach the required heat transfer area.