Nowadays, more and more people use the fine Speed Control Gear Motors Suppliers, not only because of its good performance, low energy consumption, but also cost-effective, I also don\u2019t reveal the actual price. As everyone knows, the advantages don\u2019t mean it\u2019s not easy. Common failures occurred. Many people neglected such problems and caused the reducer to be destroyed for a while. What are the main common failures?1. Many wrong operations: Because of insufficient control of the structure and performance of the reducer (especially for new operators), it is very easy to cause common failures due to wrong operations, and even cause mechanical equipment safety accidents and safety production accidents.2. Faster wear speed: Because of the hazards of the processing, assembly and adjustment of the new fine planetary reducer parts, the total contact area of \u200b\u200bthe mating surface is small, and the allowable torque is large. During the entire operation of the fine planetary reducer, the convex and concave parts of the parts surface are intermingled with each other and rubbed against each other, grinding the fallen metal material and slag, which is also used as a wear-resistant material to participate in the friction again, which speeds up the wear of the parts matching surface. Therefore, it is very easy to cause wear of the parts (especially the mating surface) within the running-in time, and the wear rate is too fast. At this time, if the operation is overloaded, it is likely to cause damage to the components and cause common failures in the initial stage.3. Looseness: The newly produced and assembled parts and components have errors in geometric shapes and matching specifications. In the early stage of application, they are damaged by alternating loads such as damage and vibration, and they are exposed to heat, deformation and other elements. In addition, due to excessive wear and tear, it is very easy to loosen the originally tightened parts.4. Poor lubrication: Because the matching gap of the newly assembled parts is small, and because of assembly and other reasons, the grease (grease) is not easy to produce a symmetrical floating oil on the friction surface to prevent wear. In turn, the efficiency of wetting is reduced, leading to abnormal wear in the initial stage of the parts. In more serious cases, it will cause scratches on the finely matched friction surface or tooth occlusion, resulting in common failures.5. Water leakage: due to the damage of loose parts, vibrations and the heat of the fine planetary reducer, there will be water leakage on the raised surface of the fine planetary reducer and its three-way joints; some of the forging and other shortcomings are adjusted in the assembly It cannot be noticed at times, but because of the vibration and impact effects during the whole work process, such shortcomings are exposed, mainly manifested as oil leakage (seepage). Therefore, the running-in time sometimes leaks.