But if your D-Sub Connector Manufacturers raises requirements related to data rate, cable design, highly flexible components, and overmolding, you may have no choice. In order to find the right interconnection solution, you will need to find the right supplier. In other words, find a supplier who can meet all your needs in a cost-effective manner. At this time, there are four key capabilities that need to be considered: custom design and manufacturing, custom assembly, contract manufacturing, and custom overmolding. In an increasingly competitive market, it is more important than ever to choose a suitable interconnection supplier that can meet all your customized interconnection needs. As electronic packaging becomes lighter and more portable, the industry has a unique need for highly flexible cables, slingshot cords, and custom coatings.The choice of conductor material, the number of wire bundles, the main sheath compound, shielding and overall sheath, each of which is a key factor affecting product performance. These materials must all work as a complete system. Not only the choice of materials, but also the parameters used in the manufacturing process will also affect the results. The cable must be connected to a connector system, and then force is applied to form an appropriate overmolding with special materials to improve performance. Achieving this goal usually requires finding a vertically integrated interconnection supplier that has experience in cables, cable assembly and overmolding. Current technology-driven companies need cable systems (combination of cables, overmolding, and assembly experience), not just cable assemblies, to get the desired results. There are 16 surface contacts between the flash cavity of the molded product before the improvement and its matching cavity, but only 4 surfaces are in contact after the improvement. In this case This will result in poor 'adhesion' between the cavity and core during mold clamping, resulting in burrs.1 Product appearance burr improvement The structural characteristics of the product determine that the plastic part may have burrs where the slider is formed. The improved cavity has an arc of R0.