Squeeze some detergent into the bucket, then add warm water and shake well. When cleaning wooden clubs, do not put the ball head indoors, otherwise the club will crack. Next, use a toothbrush or other brush to clean the bottom and head of the iron to remove dirt. At this point, the cleaning of the irons is complete. Clean the club head: Rinse the club head dry with a tap. Please note that the water is only slightly warm, not too high (because thermal expansion may cause the metal hoop on the iron to fall off). Just wait for you to put them in your bag and walk on the court with a happy mood. Note, try to keep the club head and neck above the water.The amount of water is appropriate to submerge the club head. Be careful not to splash water on the shaft. Clean the grooves on the face: After soaking for 1-2 minutes, pick up the iron rods one Wholesale Fishing Accessories Tools Suppliers by one and use an old toothbrush (or other plastic brush) to remove the grooves on the face. Put the iron rod in the bucket: Bring the prepared water to the faucet for irrigating the garden outside the house, or wash it directly in the sink. Prepare cleaning materials: first find a bottle of neutral detergent, then find an old toothbrush or other plastic brush, and also need an old towel and a plastic bucket.The golf club equipment needs to be cleaned and maintained after a period of use, otherwise the soil or other substances contaminated on the club will cause damage to the club and affect the effect of the shot. The following editor will introduce to you the cleaning method of golf club equipment, I hope it will be helpful to you. It should be noted that iron golf club equipment can be cleaned according to the above method. Prepare washing water: place the plastic bucket in the sink or bathtub. This is a very important step in cleaning irons-removing all dirt and residue.Let the iron soak in warm water for a few minutes to gradually loosen the dirt on the club head, and the grease or other chemical residues on the court will also be diluted in the water. Of course, if the dirt on the iron rod has become hard for a long time, it will take more time to soak and use a hard brush to clean it. Put the bucket down and soak the iron club head in the bucket. Dry the club head and shaft: Use an old towel to dry the club head and wipe the shaft at the same time to remove dirt and water on the club head and make the iron as clean as new. Wipe it with a wet towel and wipe it off with a dry towel. It is recommended to use a soft brush to avoid wearing the iron.