1. The latest method of paint stripping for enameled copper wire (BT-104 copper wire stripping powder) is specially used for the stripping of AI (200) and PI (220) wires used in voice coils, and is suitable for assembly lines.2. The latest method of paint stripping for enameled copper wire (BT-104 copper wire paint stripping powder) is heated to 300-350℃, and the paint is melted directly without leaving any paint.3. The latest method of paint removal for enameled copper wire (BT-104 copper wire paint removal powder) is environmentally friendly (passed by RoHs test), fast, and it can be removed in 3-5 seconds.Technical parameters:BT-104Enameled WireStripper is white powder;Process:Enameled wire → immerse in stripper for 3-5 seconds (heat to 300-350°C) → wash in water → dip in BT-122 red water → wash in water → solderPackaging, transport and storage (Packaging, transport and Storage)BT-104 is packaged in a 500G/bottle strong acid and alkali resistant plastic bottle. 20 bottles per carton;This product should be stored in a dark and dry place below 25℃, and should be stored separately from organic matter, reducing chemicals, and acidic substances. The shelf life is 12 months;Fuda enameled wire tips: Avoid exposure to sunlight, rain, high temperature, leakage, extrusion, and breakage during transportation.AttentionSince this product is used under high temperature conditions, you should pay attention to safety when using it. Wear protective gloves, protective clothing, masks, and glasses. Do not touch the skin to avoid splashing your eyes and skin. If it splashes on the skin, you can rinse with plenty of water (seriously necessary Seek medical diagnosis at any time); in the beginning of the heating process, the iron cover should be covered to avoid splashing of the paint remover due to uneven heating when the temperature rises and melt; open the cover until the paint remover is completely melted, and then use it normally; because of the paint remover powder It has strong moisture absorption, and should be sealed and stored when you stop using it to prevent moisture. If you need to use it again, you should first use a dry cloth or paper towel to absorb the surface moisture, then cover it and raise it to 100℃ for a period of time. After the moisture evaporates, the temperature will be raised to 350-380℃.