Reassembly of the heat exchanger: 1. Before reassembling the components of the heat exchanger, the qualified heat exchange plates, gaskets, heads, clamping bolts and nuts must be scrubbed clean. 2. Before the heat exchanger sealing gasket is bonded to the groove, acetone or other similar organic solvents must be used to melt the residual glue in the groove, and then wipe it with a fine gauze cloth. 3. Using a bristle brush with the same width as the groove of the heat exchanger sealing gasket, apply the synthetic resin adhesive to the groove of the plate, then press into the sealing gasket, flatten it with a flat steel plate, and leave it for 48 hours. . 4. Use organic solvents such as acetone to dissolve and remove the residual rubber squeezed out of the groove. 5. When replacing the new gasket, carefully check the four corner empty positions of the new gasket, which must be the same as the old gasket. 6. When one plate of the flat heat exchanger is damaged and there is no spare part, this plate and the adjacent plate can be removed at the same time, and then tighten the clamping bolt. 7. The clamping bolts should be tightened evenly, symmetrically, and crosswise until the length of the plate bundle reaches the calculated value. 8. In order to prevent the heat exchanger gasket from sticking to the plate, a layer of mixture can be applied to the gasket. The ratio of oil, alcohol, and talc used in the mixture is 1:1:2 by weight.Medium repair: hanging heat exchangers the inlet and outlet pipes of the heat exchange unit to clean the debris; check the rubber lining of the inlet and outlet pipes, there should be no cracks and damage, otherwise relevant treatment should be carried out. Check and measure the pre-tightening force of the bolt and the overall size of the plate. Overhaul: including the content of mid-repair; if the heat exchange unit is fouled, it should be disassembled and cleaned, or another piping for online chemical cleaning; use a magnifying glass to check the elasticity and compression deformation of the sealing strip, and replace it if necessary; check the heat exchange plate of the heat exchange unit Sheet deformation; check the heat exchange plate for defects such as corrosion and perforation.
