The best thing that a pool owner can do to ensure that an in ground pool heating device remains in full operational order is to make sure that they have the in ground pump serviced by a professional on a regular and consistent basis. It is a good idea to document when the pump is serviced as well; this will allow the pool owner to have an adequate record of all maintenance performed. There are techniques which are fully certified and licensed capable of assessing the in ground pool pump and in making sure it is fully operational and functioning properly. The expert can also advise the pool owner about any necessary repairs, which may reduce the need for more costly repairs in the future.A technician that is fully pwht equipment qualified to examine the in ground pump can check the amount of amp draw the device is using, all of the electrical connections, the amount of refrigerant and more. A qualified technician can also lubricate any internal components which require regular lubrication, and can remove any potential clogs which would hinder the pump\u0092s operation. By far, one of the best troubleshooting heat pump tips a pool owner can receive is that he or she should keep the pump well maintained at all times. By addressing the simple issues that occur in heat pumps as early as possible, the potential for costly maintenance and\/or replacement are significantly reduced.The pump owner must also be careful with the pump installation. In order to ensure that a heat pump always works the way it should, it must be properly installed. If after install the pump fails to work appropriately, there are a few troubleshooting steps the pool owner can take. First off, the installed ground heat pump requires 50 cm of clear area around the entire device in order to work properly; the device needs this so that the ventilation system can work. Inappropriate spacing around the device will eventually cause the device to become inoperable. If the heat pump has been improperly installed in an enclosed area, it will need to be moved to ensure adequate ventilation at all times.The heat pump also requires the right amount of electricity flowing to it in order to prove functional. If the requirements for electricity are not met and the appropriate sized cables are not used, again the device will not work. In addition, if the owner is to derive the silent operation features supplied by an in ground heat pump, then the pump must be situated on a perfectly level, flat location. It is a good idea to have an expert make the initial install of the heat pump so that the device is set up correctly.