* Along with opting for S load cell , which are usually used by many, you can also choose the option of parking sensors based on electromagnetic technology.The fact of the matter is that if you have to park your car in tight spots these parking censors are just perfect for you. Not only will they help you find a right place for you car but they will always help you to stay away from damaging another person's car. So, let sleeping dogs lie and opt for sensors to make your driving life more comfortable.Now, because this is an article written on the general process of removing an oxygen sensor, remember that each vehicle is different and could have other things that need to be removed or replaced along the way.Step One: Locate your Oxygen SensorOn most vehicles, you will find your Oxygen Sensor located on your exhaust somewhere. On front wheel drive vehicle you will often find it on the front side of the engine when you open the hood. On rear wheel drive engines you will most likely find it located under the car right below the donut gasket. There are often 2 Oxygen Sensors on rear wheel drive engines on either side of the exhaust piping.Step Two: Remove the Oxygen SensorFirst, you will need to see if your oxygen sensor has a wiring harness that can be removed from the tip of the sensor, or if it will need to be pulled off somewhere on the engine. Remove the harness to make removing the oxygen sensor easier. Then take your adjustable crescent wrench, adjust it to the appropriate size and unscrew the sensor from the exhaust.Note: robot torque sensor is very useful to have some Penetrating Lubricant around to help you loosen the seal on the Sensor.Step Three: Put in Your New SensorThis step will seem a little weird because the best way to put in the new sensor is to have the wiring already connected, then turn the sensor a bunch until the wiring is bound up a bit and then start it into the hole where it needs to go. Then just tighten it into place. It might take a couple of tries, but just remember that you can do it!Some things to remember before starting this project:*Make sure you have all tools necessary for oxygen sensor replacement.As you see, using shear beam load cell has a set of advantages that are handy in the practical life. So it is of no surprise that people are appreciating these sensor lights today more than ever before. Load Cells and Force Sensors for Punch Machine