What is remote access, then? small load cell is an ability to access your home security system through any web enabled device (such as through your smartphone) in order to view your system's status, receive e-mail or text alerts, or view your camera feed.The lights in conference rooms in hospitals are often left on and could be turned off automatically using an occupancy sensor, the same with restrooms where the lights could move from a lower level of lighting to a higher level of lighting which is more practical than motion controlled on/off lighting.Once you have accepted that investing in controls to reduce lighting cost and maintenance makes extreme sense, here are some important issues to consider; try to stay with simple systems, which are self-contained so that you do not need a PC to turn on your light. A motion sensor / dimmer should be intuitively programmable on the dimming device without further hardware or know how required. A street light with daylight sensor or a high bay fixture with motion sensor should be re-programmable from the ground using infrared (IR) from a Laptop with an IR dongle.In 3 axis load cell use only simple and self-contained devices that can detect motion as well as setting dimming levels, that may be IR controlled via a remote control in a bedroom or the living room. For safety and convenience in the Garage or the Utility Room use motion control devices for. Use daylight sensors and timers for landscape lighting and daylight and motion sensors for perimeter lighting.Only use simple devices that can be motion operated in a hallway, that may be IR controlled via a remote control in the office or the conference room. Definitely motion control for the Printer/Mail Room or the Server Room.Restrooms and Kitchen areas definitely benefit from motion controls and Active Rest at 20% or 30% with such simple controls you may be able to light five restrooms and a kitchen area for $34 a year @ $0.11 a kWh.Only use simple devices that can be motion operated in a hallway, that can be daisy chained, that may be IR controlled via a remote control in the office or the conference room. Definitely motion control for the Printer/Mail Room or the Server Room.weighing indicator may reduce the need to personally monitor the locations or enforce rules to the availability of maximum light levels. This can be achieved using LightSpace Concentrators that can be connected to the Internet for remote event and use monitoring and following server applied rules. However, a server managed system should be locally self-sufficient. In case the Internet connection fails, the localized daylight and motion controls should remain fully functional and control the lights via the local LightSpace Controller(s).Larger In-Door Systems' controls should be battery backed up and better still light fixtures and LightSpace controllers should be able to be supplied by line power and/or 48V-DC power for backup or permanently powering the devices from DC.For larger un-covered parking spaces the only practical control are timers and/or daylight sensors combined with timed and controlled light output.http://www.bransensor.com/product-06-t905-load-pin-load-cell-with-high-accuracy-21119.html
