What can I do if the sea pole enters the water? The sea pole will inevitably enter water during use. Before it pulls the tip of the rod, it is already hooked. Slowly shake it back and experience the friction between the plumb and the bottom. Putting it in different positions will produce different fishing methods, either bottom fishing or fishing float. Use soft thread as much as possible. The two ends of the line are knotted and buckled.I have more than a dozen sea rods, 7 of which are above 3. Lead sinker fishing method: This method is suitable for waters with a depth of less than two meters, and deeper waters are not suitable for use due to low sensitivity. Some sea rod players are also closing their rods. Before fishing, you must first hit a dozen shots into the fishing position, and try to hit more accurately, and the bad food should be larger in order to form a nest. The wheels should also be cleaned with clean water by opening the side cover, because sea water is more corrosive to metals. The action of the plummet is different. Wholesale fishing tackle accessories tools After the sea rod enters the water, it must be treated and dried.7 meters, and several hand-sea rods. The downwind of the reservoir is already turbulent, and the water splashes up to the shore. After the rod is hit, the water line must be pressed to reduce the displacement of the fishing line by the wind. In comparison, the sensitivity is slightly worse, but the loss of lead sinkers and fish hooks is avoided. When the sea rod falls into the sea, it should be washed thoroughly with clean water in time, and then dried, because the seawater is more corrosive to the fishing rod. According to different underwater conditions in different waters, choose different fishing methods, bomb hooks, string hooks, fly hooks, bento boxes, grape beads, mushroom food [noodles], etc. Strike against the wind should take into account the influence of the wind, and have some advance, try to hit one place as much as possible to form a nest. . Put the pole on the ground and keep it parallel to the shore. There is no way to be foolish at two meters. There are two ways for fishing clubs to use sea rods for fishing floats, one is to sink the lead to the bottom of the water, and the other is to sink the lead to the surface of the water. When you have this kind of thread in your hand, you must first break it once to obtain the ultimate tension value. The hook pulls out the bait, and the fish does not eat the empty hook at all. 3 After changing the thin line, the wheel will inevitably have a large circle, and the line will inevitably rub against the wheel body when it passes, reducing the flying distance of the fishing set. This method is suitable for fishing more than a catty of fish. The length of the waterline should be adjusted according to different waters and the living habits of different fishes. When fishing at night, you can hang a bell on the tip of the pole, and then use a transparent tape to tie a light-emitting stick to the tip of the pole. If you do not pay attention to handling after the water enters, the sea pole will be damaged. Half-dead lead pendant: Use an ordinary heart pendant, not worn on the main line, but on a short line.. I always think my own rods don’t go far. After the pole is hit, the lead falls into the bottom of the water, and the float floats with the hook. This fishing method is best to fish downwind. The line is too thick. After the line is tightened, the float and the lead sink are in a vertical state. Fishing float close to the surface of the water: According to the length of the waterline, add a fishing float on the lead sinker. The most common thing is that the paint changes the color, which makes the appearance very unsightly. The method is to hang a plumb on the pole and hit the fishing point without the hook. This method has good stability and the float does not move. They don't know that we have a smart way to deal with the high winds. You can pull out half of each section of the sea pole and place it on an electric mattress to heat it to evaporate the water