In the original situation, the power is low, the workload is stagnant, resulting in overtime, simpler, and the damage of the shredder increases, the maintenance cost is increased, and the economic benefit is reduced. Plastic tearingers are widely used in the recycling of waste plastics and the bucket recovery of the factory. . The round tube type feed port designed for pipe is designed to facilitate the pulverization of the long tube, and improve work efficiency. 2, the rectangular feed port is designed for the blade breakage, which is convenient for the pulverization of the long stripboard and improves working efficiency.The utility model structure is between the claw knife and the flat knife, which is suitable for the pulverization of plastic plastic shredder products such as ordinary sheets, pipes, profiles, sheets, packaging materials. Plastic tube and plastic shredder 1, suitable for pulverization of various small and medium-sized plastic tubes, such as PE, PVC tubes, silicon core tubes, etc. Third, the hard plastic shredder 1, ABS, PE, PP plate and other plates are smashed.The bearing adopts the sealing bearing, so that the bearing is well operating in a long time, the knife / design is reasonable, the product particles are uniform, the tool holder is heat shrink, and the design is beautiful.What is the classification of the plastic shredder? Plastic Tear for tearing waste plastics and plant plastic waste. The following is three categories of a plastic shredder: Second, strong / force plastic shredder 1, the ordinary shredder adopts a sealing bearing, so that the bearing is working well; the knife / design is reasonable, using alloy steel blades to make the product particles uniform; the tool holder heat shrinks, through strict balance test The appearance is beautiful.