If you encounter a problem that is difficult to solve in the process of using the plastic mill, please call us for consultation. How can we solve this problem? Usually in the production process, the start-up of the mill is started according to a fixed procedure.What to do if the mill cannot start normally Items to be inspected before plastic crusher production and operation Huibang analyzes the reasons for Double Shaft Metal Shredder the high efficiency of my country's plastic mill products Equipment characteristics of Jiangsu PE mill. are loose., adjust the rotation of the fan and the main engine, and then check whether the exhaust valve of the equipment is in place. In addition, it is also very important to determine the voltage stability before starting. Firstly, check whether all the inspection doors are tight, whether there are sundries in the machine, etc. However, if the equipment is not started up according to the normal start-up procedure, it will cause certain damage, and if the troubleshooting is not done well, the machine is mixed with debris and the exhaust valve is not fully opened, which will cause the mill to be in the working process. Users don’t have to worry, Kelirik will give you a solution right away. Fully open position, check whether the screws, etc. In addition, any adjustment, cleaning or maintenance work is strictly prohibited during the operation of the equipment, and it is strictly prohibited to peep into the machine from the upper part of the mill cavity during operation. When the mill equipment is working , Will burn the equipment. After all preparations are made, follow:'Start' the hoist-crusher the feeder turns on the machine smoothly. The voltage should be lower than the rated voltage of the motor, but not too much lower than the rated voltage. What's wrong? The pulverizer cannot start normally is related to our economic benefits. Recently, a user called and responded to a situation. They were about to turn on the plastic pulverizer in the morning and suddenly found that the pulverizer could not start normally. Some human factors, such as the accumulation of ash due to overload or jamming of objects, and the smoothly upside down of the equipment, can also cause harm to the mill and milling equipment.
